10.0.0.129: Created page with "==Normal Usage== # Turn probe on (Green light should come on) # Log into QC # Any form with a temperature sample control should cause the light on the probe to flash quickly f..."

2015-06-26T01:08:05Z

Created page with "==Normal Usage== # Turn probe on (Green light should come on) # Log into QC # Any form with a temperature sample control should cause the light on the probe to flash quickly f..."

New page

==Normal Usage==
# Turn probe on (Green light should come on)
# Log into QC
# Any form with a temperature sample control should cause the light on the probe to flash quickly for a few seconds. Leaving and reentering the form will cause QC to reattempt to contact the probe.

==QC Form Setup==
# Add sample control to your form
# Change Equipment Type to "Temperature"
# If a specific probe is required, enter the devices [[QC serial number]] into the Serial Number field.

==Initial Setup for Windows Mobile==
# Turn Probe on
# Goto Settings>>Connections>>Bluetooth
# Click “Add new device”
# Follow the steps in the wizard. When asked, the Passkey is 004321
# Click on the Intelliprobe in the Bluetooth devices list.
# Check the box “Serial Port” under Services to use
# Click “Save”
# Click on the “Com Ports” tab
# Click “New outgoing Port”
# Pick a com port (above 7 works better since several of them are used internally by most Handhelds)

[[Category:Equipment]]

IntelliProbe - Revision history

10.0.0.129: Created page with "==Normal Usage== # Turn probe on (Green light should come on) # Log into QC # Any form with a temperature sample control should cause the light on the probe to flash quickly f..."